One thing about the current Mazda look. It's unmistakable. So what if it doesn't necessarily fit the proportions of every vehicle to which it's applied. Which is much the case with the 2007 CX-7, especially the front end.For starters, the fenders are seemingly transplanted directly to the CX-7 from the company's sports car, the RX-8. To fit those bulbous wheel housings to a sedan-like body required pinching the front end's nose and squeezing headlights into the tops of the fenders. This leaves substantial mass below the bumper line that's only slightly lightened by a massive mouth braced by large intake-like recesses that double as housings for the optional fog lamps. The way the CX-7's bulk is suspended between the exceptionally wide track (distance between the tires side to side) leaves it looking almost as if it's drooping, or sagging, from the weight. The side view appeals more, with wheels pushed to the corners and a super-fast windshield sweeping back over tautly drawn side glass. Side mirrors separate the front door glass from an odd-looking, windwing-like, but fixed, tiny piece of glass at the base of the A-pillar. The beltline rises as it moves rearward, peaking just aft of the severely blistered rear wheelwell before tucking in between the steeply sloped backlight and the sculpted back end. Full-round, easy-to-grab door handles ride the crest of a soft bulge connecting the tops of the fenders. An understated crease highlights the lower door panels, skipping over the rear tires to continue around the bottom fold of the rear bumper. The rear aspect is somewhat plain, with a modest spoiler sitting atop the backlight, itself resting in a gentle dip in the liftgate. A rather large, seamless bumper stretches the width of the back end, above a widespread pair of exhaust tips, this last a feature that's beginning to wear. It works on a vehicle boasting a robust powerplant under the hood, preferably a V8 or some other V-configuration, where each pipe nominally runs directly back from its bank of cylinders. But for draining burnt gases from an inline engine, especially an inline-4, and one sitting transversely, to boot, it's a bit overdone. A single pipe, or maybe two running tightly parallel and exiting out one side, seems more fitting.
|